Welcome to ecuobd2.com!
Search Site

Cart 0 item

TOYOTA 3 Button Remote control USA 314.4MHZ HYQ12BBX for 2005 2006 2007 2008 2009 4Runner 2005 2006 2007 2008 Sequoia

SKU: TRK-TOY-R22-2

Availability: In stock

$27.00

Weight: 0.10 kg (Add to Cart to Estimate Shipping Cost)

314.4MHZ
FCC ID:HYQ12BBX
Work On:
2005 2006 2007 2008 2009 4Runner
2005 2006 2007 2008 Sequoia

You may also be interested in the following product(s)

Toyota 2button Smart Card

Toyota 2button Smart Card

$120.00
Toyota 2 button Remote Key 50171 433MHZ 4D-67chip inside

Toyota 2 button Remote Key 50171 433MHZ 4D-67chip inside

$40.00
Toyota GPS smart Remote

Toyota GPS smart Remote

$10.00
Toyota 3 button Case(slider door)

Toyota 3 button Case(slider door)

$4.00

Details

314.4MHZ
FCC ID:HYQ12BBX
Work On:
2005 2006 2007 2008 2009 4Runner
2005 2006 2007 2008 Sequoia

 

Programming Instruction

1. Start with the key out of the ignition, drivers door is open all others closed and
    drivers door is unlocked.

2. Perform these steps within 5 seconds.
    A. Insert the key into the ignition(Do NOT Turn) Pull key out.
    B. Insert the key into the ignition(Do NOT Turn) Pull key out.

3. Perform these steps within 40 seconds.
    A. Close then open the drivers door.
    B. Close then open the drivers door.
    C. Insert the key into the ignition(Do NOT Turn) Pull key out.

4. Perform these steps within 40 seconds.
    A. Close then open the drivers door.
    B. Close then open the drivers door.
    C. Insert the key into ignition and leave it in ignition.
    D. Close the drivers door.
    E. Turn the ignition to ON (Do NOT Start) then back to OFF.
    F. Remove the key from the ignition.

5. Within 3 seconds, the power door locks should lock then unlock automatically
    indicating successful entry into programming mode.
    Return to step 1 if the locks do not cycle at this point.

6. Perform these steps within 40 seconds.
    A. Press the lock and unlock buttons on the remtoe simutaneously for 1.5 seconds.
    B. Immediately after letting go of the lock and unlock buttons,
        Press the lock button by itself and hold for 2 seconds. Within 3 seconds, the door
        locks should lock and then unlock once indicating successful programming. If
        the door locks cycle twice, repeat steps A and B in step 6 as the remote was
        not accepted.
    C. Repeat steps A and B in step 6 for each new remote.

7. Open drivers door.

Use spaces to separate tags. Use single quotes (') for phrases.

Product Reviews

Write Your Own Review

Only registered users can write reviews. Please, log in or register